Talkaphone WEBS-RETRO-MT WEBS Retro Kit for ETP-MT Towers Manuel d'utilisateur télécharger pdf

WEBS-RETRO-MT Installation Instructions

Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714-3804 Rev. 7/27/09

Phone 773.539.1100 • Fax 773.539.1241 • info@talkaphone.com • www.talkaphone.com

All prices and specifications are subject to change without notice.

Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.

I. Introduction

The WEBS-RETRO-MT is a kit that converts an existing ETP-MT Tower to a WEBS

-capable Mass Notification

Unit. This instruction manual assumes that a fully functional ETP-MT Tower has already been installed.

II. Contents

Before beginning installation, make sure you have all the included components. Each kit consists of two

packages. Package #1, labeled WEBS-RETRO-MT contains the painted WEBS

retrofit tower top. Package #2,

labeled WEBS-RETRO-KIT contains the following:

QTY Part Number Description

4 83073 WEBS

Loudspeaker

24651 Amplifier Mounting Bracket

NA Paging Amplifier

NA 2’ Extension wire for WEBS

loudspeakers

3 42841 10-24 x 3/4" pan head tamperproof screw

2 42839 3/4"-10 hex nut

8 42840 3/4" washer

4 42847 10-24 Hex nuts for Amplifier Bracket

III. Installation

(A) Installing the Retrofit Tower Top

1) Unplug the strobe light from the power supply and the emergency phone.

2) Take off the strobe light attached to the top of the tower by unfastening the three 10-24 x 3/4" pan

head tamperproof screws and keep them safely aside.

3) Remove the cap plate of the retrofit tower top and fasten the unit to the top of the tower with the help

of the three 10-24 x 3/4" pan head tamperproof screws provided.

4) Install the four WEBS

loudspeakers by locking each down with the retainer bracket starting with the

bottommost speakers first (see Figure 1).

5) Fasten the strobe light to the top of the cap plate of the WEBS

Speaker Unit with the three 10-24 x

3/4" pan head tamperproof screws that were kept aside.

6) Pass the speaker and strobe light wiring through the center hole at the bottom of the retrofit top and

down to the bottom of the tower.

7) Close the top of the retrofit tower top with its cap plate and reconnect the strobe light wiring to the

emergency phone and to its power source.

1 2 3 4

Figure 1. Installing the WEBS 2

Résumé du contenu

Page 1

Page 2 - Figure 1. Installing the WEBS

Page 3

Page 4

Commentaires sur ces manuels

Pas de commentaire

Talkaphone WEBS-RETRO-MT WEBS Retro Kit for ETP-MT Towers Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires de communication Talkaphone WEBS-RETRO-MT WEBS Retro Kit for ETP-MT Towers. Talkaphone WEBS-RETRO-MT WEBS Retro Kit for ETP-MT Towers User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires de communication Talkaphone WEBS-RETRO-MT WEBS Retro Kit for ETP-MT Towers